MediaMatrix nTouch 180 Handbuch PDF herunterladen (Seite 20)

Chapter 4 - Installing the unit

16 Version 1.7.2.0 March 27, 2015

Before you start

Before you start the installation, it is important to consider the implications for your network

and power supply system. The infrastructure must be designed and installed correctly, in order

to provide reliable and error-free performance.

Unpacking the nTouch 180

1. Remove the unit from its packaging.

The LCD screen has a protective plastic cover attached to it. Only remove this

cover after the unit has been properly installed. The cover helps protect the screen

during the installation process.

2. Remove all the other items from the packaging.

3. Check that you have all the items listed below:

 nTouch 180

 Power adapter with cable

 IEC power supply cord

 Blue USB stick labeled MediaMatrix for system recovery

 Blue touch screen pen

 User literature package.

If any of these items are missing, please contact your Authorized Peavey MediaMatrix

contractor/dealer.

4. Retain the packaging. It must be used if the unit is transported for any reason.

Physical installation

There are several ways to mount the device:

 Into a wall, using an in-wall mounting kit

 Onto a wall

 Into a panel

 Onto an arm

 Into a rack.

Read the remainder of this section and then refer to the instructions provided with your

mounting device in order to complete the installation procedure.

The unit uses a standard 75mm VESA mount. Ensure that you use an appropriate bracket and

appropriate screws for this type and size of mount.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 57 58

Keine Kommentare

MediaMatrix nTouch 180 Handbuch Seite 20