MediaMatrix nTouch 180 Handbuch PDF herunterladen (Seite 34)

Chapter 5 - Setting up the nTouch 180 unit

30 Version 1.7.2.0 March 27, 2015

For example:

Eastern Standard Time|America/New_York

8. Save the file.

9. Close Windows Explorer.

10. On the System menu, press Restart.

11. Click Yes.

Displaying the Command Prompt window

You can display a standard Windows Command Prompt window and then type in commands

directly.

Note: Changing settings can have adverse affects on the operation of the unit, so it is very

important that you only change them when instructed to do so by MediaMatrix Technical

Support.

 To display the Command Prompt window

1. On the main set up screen, press Advanced.

A warning message is displayed.

2. Press Continue.

3. Press CMD Shell.

A Command Prompt window is displayed.

4. Perform the actions you have been instructed to perform by MediaMatrix Technical

Support.

5. When you have finished, type Exit.

Using the web interface

Starting the web interface

The procedure below assumes that you are going to start the nTouch 180 web interface from

within NWare, which locates and lists all nTouch 180 units and other MediaMatrix devices,

automatically. However, if you know the IP address of the unit, you can type it directly into the

location field of your browser, and you will be connected.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 57 58

Keine Kommentare

MediaMatrix nTouch 180 Handbuch Seite 34