MediaMatrix nTouch 180 Handbuch PDF herunterladen (Seite 21)

nTouch 180 Hardware Manual

March 27, 2015 Version 1.7.2.0 17

If you are mounting the unit into a cavity, such as a panel, you will need to make a cut out as

shown in the diagram below.

Note: It important to use appropriate mounting hardware. For example, when attaching to a

drywall, use screws with wall fixings, rather than nails.

The nTouch 180 requires 12VDC power. Each unit is shipped with a power supply capable of

12VDC at 3A max (36W max). You can choose to power the nTouch 180 locally by placing

this power supply near to it, or you can power the unit remotely with an industrial 12VDC

power supply.

When connecting an external power supply, note that the plug is wired with the

ground on the sleeve of the barrel and the +12VDC connected to the center pin. The

warranty does not cover issues caused by power supply polarity reversal.

We recommend that two people complete the installation, to ensure that the unit

does not get damaged, particularly when it is mounted in a position where it may

fall.

Do not block any of the ventilation openings.

Note: Do not turn the unit on until instructed to do so later in this manual.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 57 58

Keine Kommentare

MediaMatrix nTouch 180 Handbuch Seite 21